General Purpose saws are designed for general sizing and cutting of natural woods. A higher number of teeth provides a finer edge to the cut but should be used only on thinner material.

Designed for ripping soft or hard woods where chiseling action of FTG is effective. FTG is the fastest most efficient tooth design for ripping.

Polycrystalline Diamond (PCD) saw blades are designed to cut faster, cleaner, and will last 150 times longer in cutting cement board like Hardiplank®.  PCD blades are not intended to cut...

This blade is good for cutting laminates, melamine, coreboard and other composite materials. Made with Micro-Sheen C-4 sub-micron carbide for an extended life. The Hollow Face (HF) Grind provides a...

This dado set includes 7 pieces (2 outer blades and 5 chipper blades) which provide super smooth, splinter free cuts. 2 outer blades and 4 chippers have a kerf of 1/8" each and 1 chipper has a kerf...

Combination saws are designed for all around use, when acceptable rips and crosscuts must be made with one saw blade. The larger gullets allow deeper cuts and efficient saw dust escape on rip cuts...

Designed with contractors in mind.

These steel cutting saws use micro-grain tips with titanium to provide greater impact strength and durability. Can cut through ferrous metal such as angle iron, steel pipe, flat bar, and rebar...

These saws are designed for high production cutting of natural woods, plywood, chipboard, and MDF. The TCG teeth offer less wear than the ATB with nearly the same quality of cut. 

These saws are designed similar to the general purpose saw but with a negative hook angle to prevent grabbing. The negative hook is a safety feature to prevent the cutting material from climbing up...