FAQs

Expect 3-5 business days on our end plus several days shipping both ways.

W4481 South Cherry Road Phillips, WI. 54555.

Yes, you can send us all your different saw blades. We recommend to our customers that any blade purchased for under $35 dollars to purchase a new saw blade instead of sending it in to us for sharpening.

• Superior blade performance reduces energy consumption and material waste.
• Less chip removal means less airborne sawdust which gives better air quality in your shop.
• A smooth finish eliminates most customers' need for sanding.
• A quieter saw means less decibels which protects the hearing of you, your family, and your co-workers.
• Effortlessly gives the best quality cuts in all woods and most plastics.
• Has the ability to cut paper thin strips of wood with ease.
• Special tooth grind allows the blade to cut through knots.
• Cuts thin (0.061”k) with extreme ease.
• Cuts excellent in the cheap, under-powered, portable table saws.
• Uses less electricity, produces less sawdust, provides a thinner cut and, therefore, gives more profit.

• The 10” Micro-Kerf is capable of cutting 2-5/8” deep, but we strongly recommend not cutting more than 2” deep, maintaining 1⁄2'' tooth clearance up through the workpiece, which will keep the saw blade stable and cool. Do not allow the mounted saw blade collars to rub on the insert plate or the underside of the wood being cut. This will heat up the saw blade and cause damage. PLEASE NOTE: This blade is not a skim cutting blade. If you need to skim cut, the 10” Micro-Kerf Deep Cut is the blade to use.
• The 10” Micro-Kerf Deep Cut is capable of cutting 3-1/4” deep.
• The 12” Micro-Kerf is capable of cutting 3-1/2” deep.
• The 12” Micro-Kerf Deep Cut Saw Blade is capable of cutting 4-1/4” deep.

10-15 times, depending upon how dull the blade is each time it is sent to us for sharpening.

We do not recommend it. The Micro-Kerf saw blade is too thin to take the risk of ruining it. To maintain the proper tooth grinds and blade flatness, we recommend sending the Micro-Kerf saw blade to us for servicing. We ensure a +/- .001 runout to keep the Micro-Kerf precise in its cuts.

• US$20 to sharpen 10”.
• US$25 to sharpen 12”.
• US$7 minimum time charge to straighten the blade.
• Customers are responsible for shipping charges.

The Micro-Kerf is manufactured in our facility in Wisconsin.

No, we only sell the Micro-Kerf directly through our company.

• Most table saws are out of alignment. Before you use the Micro-Kerf you need to properly align your table saw. Failure to properly align your table saw will result in wandering cuts and an overheated blade. Standard kerf saw blades will not amplify an out of aligned table saw like the Micro-Kerf will.
• To achieve a smooth-cutting finish, it is important to maintain a ½” tooth clearance through the material being cut. If the saw tooth clearance is too high (for example, 1-1/2”), it creates a rougher finish. If the saw tooth clearance is too low (for example 1/32”), the blade may heat up and start wandering in the cut.
• The Micro-Kerf blades are not intended for full-depth scoring. Ensure the carbide tips cut completely through your material. If your intention is not to cut all the way through, limit each pass to a maximum cut depth of 1-1/2 inches to facilitate proper cutting without risking overheating of the blade.